1 HP March Pump SP-TE-7P-MD-1PH; 1.5" FPT Inlet/ 1" MPT Outlet; 115/230V

57.00 LBS
Calculated at Checkout
  • 1.5" FPT Inlet/ 1" MPT Outlet
  • 1 hp; 3450 RPM; 11.8/5.9 Amps, 115/230V 50/60hz.
  • 53 GPM; 52' Max. Head Feet
  • Conduit Box
  • One Year Warranty

DESCRIPTION: SP-TE-7-MD series are centrifugal magnetic drive pumps eliminating the need for a shaft seal. Pumps can be serviced with an adjustable wrench. OPERATION: The housing container should be filled completely with liquid. The container holds approximately 1-3/4 gallons. After the container is full and the filler cap has been screwed tight, check all the connections for any leakage. Start the motor and continue to check for any leakage. The pump has the ability to pull up water a distance of 12 feet from the surface of your supply tank to the pump within one minute. If the unit does not self-prime, then check for leakage or for obstructions. Pumps cannot be run dry because the impeller requires the liquid being pumped for lubrication. The direction of the motor rotation should be counterclockwise when facing the motor end of the pump. A trimmed impeller may be necessary when pumping a liquid with a specific gravity or viscosity greater than water as well in cases of high liquid temperature. For application assistance, contact March Pump.